Your Vehicle: 2001 Ford Escort ZX2 L4-2.0L DOHC VIN 3
 
Vehicle » Steering and Suspension » Steering » Power Steering Pump » Service and Repair » Power Steering Pump  
 
 
  Power Steering Pump  
 

Pump - Zetec
Removal

  

  1. Disconnect the battery ground cable.

  

  1. Disconnect the radiator overflow tube and position aside.

  

  1. Remove the bolt and the A/C hose clamp.

  

  1. Unclip the speed control actuator cable from the A/C hose bracket.

  

  1. Remove the A/C hose bracket.
1 Remove the bolt.
2 Remove the A/C hose bracket.
  1. Raise and support the vehicle.

  

  1. Remove the (A) bolts and the (B) RH lower splash shield.

  

  1. Turn the tensioner bolt clockwise and remove the accessory drive belt.

  

  1. Disconnect the power steering pressure hose from the power steering pump.
  2. Lower the vehicle.

  

  1. Disconnect the power steering pressure hoses from one another.

  

  1. Remove the power steering pressure hose bracket bolts.
1 Remove the bolts.
2 Position the power steering pressure hose brackets aside.

  

  1. Disconnect the heated oxygen sensor (H02S) electrical connector.

  

  1. Remove the engine block ground bracket.
1 Remove the bolts.
2 Remove the engine block ground bracket.

  

  1. Disconnect the power steering return hose from the power steering pump.
  2. Raise and support the vehicle.
  3. Remove the power steering pressure hose from the vehicle.

  

  1. Remove the four bolts and the power steering pump. Discard the power steering pump heat shield

Installation

  

  1. NOTE: Install a new teflon seal 388898-S on the power steering pressure hose fittings before connecting the hoses.

NOTE: Make sure that the threads are clean and free of debris before connecting the hoses.

Position the power steering pump and install the four bolts.

  • Install a new power steering pump heat shield.
  1. Position the power steering hose in the vehicle.
  2. Lower the vehicle.

  

  1. Connect the power steering return hose to the power steering pump.

  

  1. Position the engine block ground bracket and install the bolts.

  

  1. Connect the H02S electrical connector.

  

  1. Connect the power steering pressure hoses together.
  2. Raise and support the vehicle.

  

  1. Connect the power steering pressure hose to the power steering pump.

  

  1. Turn the tensioner bolt clockwise and position the accessory drive belt.

  

  1. Position the RH lower splash shield and install the bolts.
  2. Lower the vehicle.

  

  1. Install the power steering pressure hose brackets.
1 Position the power steering pressure hose brackets.
2 Install the bolts.

  

  1. Position the A/C hose bracket and install the bolt.

  

  1. Position the speed control actuator cable into the A/C hose bracket.

  

  1. Position the A/C hose clamp and install the bolt.

  

  1. Connect the radiator overflow tube.
  2. NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 mi) or more to relearn the strategy.

Connect the battery ground cable.