Cylinder Head
CAUTION: The bolts are torque-to-yield, new bolts must be installed or engine damage can occur.
Install the cylinder head and tighten the bolts in three stages in the sequence shown:
- Stage 1: Tighten the bolts to 20 Nm (15 ft. lbs.) .
- Stage 2: Tighten the bolts to 40 Nm (30 ft. lbs.) .
- Tighten the bolts an additional 105 degrees.
Camshaft Bearing Cap Bolts
NOTE: Apply a thin coat of silicone gasket and sealant to the sealing surface of the front camshaft bearing cap.
Install the camshaft journal caps.
- Position the camshaft journal caps.
- Install the bolts. Tighten the bolts in several two-turn passes in the sequence shown until snug.
Camshaft Sprocket
Tighten intake camshaft sprocket to 68 Nm (50 lb/ft).
Intake Manifold
Tighten bolts and nuts in sequence to 14-17 Nm (10-12 lb/ft).
Exhaust Manifold
Tighten bolts and nuts in sequence to 14-17 Nm (10-12 lb/ft).
|
