Clean all components with a suitable solvent and use compressed air to dry all parts and clean the fluid passages. Perform the following before assembly:
Inspect the inner and outer races for damage or wear.
Check the front planet pinion gears for damage or excessively worn teeth.
Check for free rotation of the pinion gears.
Inspect the pinions for excessive movement on their shafts.
Inspect the pinion shafts for security.
Check the one-way clutch for broken springs and damaged rollers.
Check the operation of the one-way clutch.
Place the (A) one-way clutch outer race on the (B) inner race and verify that when the inner race is held, the one-way clutch rotates smoothly and only in a clockwise direction.
Measure the clearance between the pinion washers and the planet carrier.
If not within the specification, replace the front planet.
Install the front planet into the one-way clutch inner race.
Install the clutch pressure plate snap ring.
Apply petroleum jelly to the planet gear bearing thrust washer and install it on the front planet.
The planet gear bearing thrust washer outer diameter for the sun gear drum side should be 84.0 mm (3.307 inch) .
