Your Vehicle: 2001 Ford Escort ZX2 L4-2.0L DOHC VIN 3
Vehicle » Engine, Cooling and Exhaust » Engine » Service and Repair » Engine System - General Information » Cylinder Bore » Cylinder Bore Honing  
  Cylinder Bore Honing  

Cylinder Bore-Honing

Special Tools

Special Tool(s)


  1. Install and tighten all main bearing caps to specification.


  1. NOTE: To correct taper or out-of-round, bore the cylinder block.

NOTE: Honing should be done when fitting new piston rings and to remove glazed surface finish.

Hone with the Engine Cylinder Hone Set, at a speed of 300-500 rpm and a hone grit of 180-220 to provide the desired cylinder bore surface finish of 18-38AA.