Your Vehicle: 2001 Ford Escort ZX2 L4-2.0L DOHC VIN 3
 
Vehicle » Transmission and Drivetrain » Automatic Transmission/Transaxle » Testing and Inspection » Monitors, Trips, Drive Cycles and Readiness Codes  
 
 
  Monitors, Trips, Drive Cycles and Readiness Codes  
 

Transaxle Drive Cycle Test

After carrying out the Quick Tests, use the Transaxle Drive Cycle Test for checking transaxle continuous codes.

  1. NOTE: The Transmission Drive Cycle Test must be followed exactly. A malfunction must occur four times consecutively for DTCs P0781, P0782, P0783, P1731, P1732, P1733 to be set, and five times consecutively for continuous DTC P0741 to be set.

Record and then erase Quick Test DTCs.

  1. Warm the engine to normal operating temperature.
  2. Make sure the ATF level is correct.
  3. With the transmission in (D), moderately accelerate from stop to 80 km/h (50 mph) . This allows the transmission to shift into fourth gear. Hold speed and throttle open steady for a minimum of 15 seconds (30 seconds above 4,000 feet altitude).
  4. With the transmission in D, moderately accelerate from stop to 64 km/h (40 mph) . This allows the transmission to shift into third gear. Hold speed and throttle open steady for a minimum of 15 seconds (30 seconds above 4000 feet altitude).
  5. Move the gearshift lever from D to (D) and accelerate from 64 km/h (40 mph) to 80 km/h (50 mph) . This allows the transmission to shift into fourth gear. Hold speed and throttle position steady for a minimum of 15 seconds.
  6. With the transmission in fourth gear and maintaining steady speed and throttle opening, lightly apply and release the brake to operate the stoplamps. Hold speed and throttle steady for a minimum of five seconds.
  7. Brake to a stop and remain stopped for a minimum of 20 seconds.
  8. Repeat steps 4 through 8 at least five times.
  9. Carry out the Transmission Drive Cycle Test and record continuous DTCs.