OIL SEAL
Removal and Installation of Front Oil Seal
REMOVAL
- Remove the following parts:
- Remove the crankshaft pulley as follows:
- Lock the ring gear using Tool attached to the starter bolt hole.
Tool number : KV10117700 (J-44716)
CAUTION:
Do not damage the ring gear teeth, or the signal plate teeth behind the ring gear when setting the stopper.
- Loosen crankshaft pulley bolt using Tool and locate bolt seating surface at 10 mm (0.39 in) from its original position.
Tool number : KV10109300 ( - )
- Position a pulley puller at recess hole of crankshaft pulley to remove crankshaft pulley.
CAUTION:
Do not use a puller claw on crankshaft pulley periphery.
- Remove front oil seal from front cover.
CAUTION:
Be careful not to damage front cover or crankshaft.
INSTALLATION
- Apply new engine oil to new oil seal and install.
- Install new oil seal in the direction as shown.
CAUTION:
Press fit straight and avoid causing burrs or tilting the oil seal.
- Press-fit oil seal until it becomes flush with the timing chain case end face, using suitable tool.
- Make sure the garter spring in the oil seal is in position and seal lip is not inverted.
- Install crankshaft pulley and tighten the bolt in two steps.
- Lubricate thread and seat surface of the bolt with new engine oil.
- For the second step angle tighten using Tool.
Tool number : KV10112100 (BT-8653-A)
- Remove Tool attached to the starter bolt hole.
Tool number : KV10117700 (J-44716)
- Installation of the remaining components is in reverse order of removal.
|