ROCKER COVER
Removal and Installation RH
REMOVAL
- Remove the engine cover, using power tool.
- Disconnect the mass air flow sensor electrical connector and remove the air cleaner assembly and air intake tubes. Refer to See: Air Cleaner Fresh Air Duct/Hose\Service and Repair.
- Remove the intake manifold collector using power tool. Remove gasket and the electric throttle control actuator. Refer to See: Intake Manifold\Service and Repair\Intake Manifold Collector.
- Remove ignition coils. Refer to See: Powertrain Management\Ignition System\Ignition Coil\Service and Repair\Removal And Installation RH.
CAUTION:
Never shock ignition coils.
- Remove camshaft position sensor.
CAUTION:
- Handle carefully to avoid dropping and shocks.
- Do not disassemble.
- Do not allow metal powder to adhere to magnetic part at sensor tip (A).
- Do not place sensors in a location where they are exposed to magnetism.
- Remove RH rocker cover bolts from cylinder head as shown.
Arrow Indicates Front
INSTALLATION
Installation is in the reverse order of removal.
Tool number : WS39930000 ( - )
- Tighten the rocker cover bolts in two steps in the order as shown.
Arrow Indicates Front
|