Insert a rod approximately 6 mm (0.24 in) in diameter through the rear of tensioner into the retaining boss to lock tensioner pulley.
Remove the drive belt auto-tensioner, with power tool.
CAUTION: Do not loosen the auto-tensioner pulley bolt. (Don't turn it counterclockwise. If turned counterclockwise, the complete auto-tensioner must be replaced as a unit, including pulley.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
If there is damage greater than peeled paint, replace drive belt auto-tensioner units.
Do not swap the pulley between the new and old auto-tensioner units.