IPDM E/R operates the ignition relay when it receives an ignition switch ON signal from BCM via CAN communication.
Turn the ignition relay OFF by pressing the push-button ignition switch once when the vehicle speed is 4 km/h (2.5 MPH) or less.
Turn the ignition relay OFF with the following operation when the vehicle speed is more than 4 km/h (2.5 MPH) or when an abnormal condition occurs in CAN communication from the unified meter (Emergency OFF)
Press and hold the push-button ignition switch for 2 seconds or more.
Press the push-button ignition switch 3 time within 1.5 seconds.
NOTE:
The ignition relay does not turn ON for 3 seconds after emergency OFF even if the push-button ignition switch is pressed.
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
PERFORM SELF DIAGNOSIS
Turn the ignition switch ON.
Erase "Self Diagnostic Result" of IPDM E/R.
Turn ignition switch OFF, and wait for 1 second or more.
Turn the ignition switch ON. Check "Self Diagnostic Result" again. Is "IGN RELAY ON" displayed?