PRECAUTIONS

Precaution

NOTE:
If any malfunction occurs in the RE0F10A model transaxle, replace the entire transaxle assembly.

• Before connecting or disconnecting the TCM harness connector, turn ignition switch OFF and disconnect negative battery cable. Because battery voltage is applied to TCM even if ignition switch is turned OFF.

• When connecting or disconnecting pin connectors into or from TCM, take care not to damage pin terminals (bend or break).

When connecting pin connectors make sure that there are not any bends or breaks on TCM pin terminal.

• Before replacing TCM, perform TCM input/output signal Inspection and make sure whether TCM functions properly or not. See: Testing and Inspection\Pinout Values and Diagnostic Parameters\CVT RE0F10A.
• After performing each TROUBLE DIAGNOSIS, perform "DTC CONFIRMATION PROCEDURE".

• Always use the specified brand of CVT fluid. Refer to See: Maintenance.
• Use lint-free paper, not cloth rags, during work.
• After replacing the CVT fluid, dispose of the waste oil using the methods prescribed by law, ordinance, etc.