ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Precaution for TCM and CVT Assembly Replacement
CAUTION:
Check if new data (Unit ID) are entered correctly after replacing CVT assembly and erasing data inTCM. (Connect CONSULT-III, and then turn ignition switch OFF.)
When replacing CVT assembly or TCM, refer to the pattern table below and erase the EEPROM in theTCM if necessary.
Perform "SELF-DIAG RESULTS" mode for "TRANSMISSION".
Press the brake pedal and turn the brake switch ON.
Press the accelerator pedal (0.5/8 - 4/8 throttle) not to exceed the half, and hold it in the half or less open position. (This will set the closed throttle position signal to OFF and the wide open throttle position signal to OFF.)
Perform "ERASE".
Wait 3 seconds and then release the accelerator pedal.
Turn ignition switch OFF.
METHOD FOR WRITING DATA FROM THE ROM ASSEMBLY IN THE TRANSAXLE
In the following procedure, the TCM reads data from the ROM assembly and writes it to the EEPROM in the TCM.