ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)
Removal and Installation
CAUTION:
Be careful of the following.
- Before servicing, disconnect the battery cable from negative terminal.
- To remove brake pipe, use a suitable tool (flare nut wrench) to prevent flare nuts and brake tube from being damaged. To install, use suitable tool (flare nut torque wrench).
- Do not apply excessive impact to ABS actuator and electric unit (control unit), such as dropping it.
- Do not remove and install ABS actuator and electric unit (control unit) by holding harness.
- After work is completed, bleed air from brake tube. Refer to See: Brake Bleeding\Service and Repair.
- After installing harness connector on the ABS actuator and electric unit (control unit), make sure connector is securely locked.
REMOVAL
- Remove front wiper arms. Refer to See: Wiper and Washer Systems\Wiper Arm\Service and Repair\Removal and Installation.
- Remove cowl top. Refer to See: Body and Frame\Cowl\Cowl Moulding / Trim\Service and Repair\Coupe.
- Disconnect washer hose.
- Disconnect the battery negative terminal.
- Remove tower bar, if equipped. Refer to See: Steering and Suspension\Suspension\Service and Repair\FRONT SUSPENSION ASSEMBLY\Exploded View.
- Disconnect ABS actuator and electric unit (control unit) connector.
- Loosen brake tube flare nuts, then remove brake tubes from ABS actuator and electric unit (control unit) using a suitable tool.
- Remove ABS actuator and electric unit (control unit) nuts.
- Remove ABS actuator and electric unit (control unit).
- Remove bracket as necessary.
INSTALLATION
Installation is in the reverse order of removal.
|