COLLISION DIAGNOSIS

For Side and Rollover Collision

FOR SIDE AND ROLLOVER COLLISION: When SRS is activated in a collision

CAUTION:
Due to varying models and option levels, not all parts listed in the chart below apply to all vehicles.

WORK PROCEDURE

1. Before performing any of the following steps, ensure that all vehicle body and structural repairs have been completed.
2. Replace the following components:

• Front seat back assembly (on the side on which side air bag is activated).
• Door finisher (on the side on which door-mounted curtain air bag is activated).
• Pop-up roll bar assemblies and pop-up roll bar covers.
• Side air bag (satellite) sensor LH/RH (on the side on which side air bag is activated).
• Diagnosis sensor unit.
• Seat belt pretensioner assemblies.

3. Check the SRS components and the related parts using the following table. Replace any SRS components and the related parts showing visible signs of damage (dents, cracks, deformation, etc.).
4. Perform self-diagnosis using CONSULT-III and "AIR BAG" warning lamp. Refer to See: Restraints and Safety Systems\Air Bag Systems\Testing and Inspection\Component Tests and General Diagnostics for details. Make sure entire SRS operates properly.
5. After the work is completed, perform self-diagnosis to check that no malfunction is detected. Refer to See: Restraints and Safety Systems\Air Bag Systems\Testing and Inspection\Scan Tool Testing and Procedures\On Board Diagnostic (OBD) System\Self-Diagnosis Function (Without CONSULT-III).

SRS INSPECTION (FOR SIDE AND ROLLOVER COLLISION)

1. Before performing any of the following steps, ensure that all vehicle body and structural repairs have been completed.
2. Check the SRS components and the related parts using the following table.

• If the front seat back assembly is damaged, the front seat back assembly must be replaced.
• If the door finisher assembly is damaged, the door finisher assembly and door-mounted curtain air bag module must be replaced.

3. Perform self-diagnosis using CONSULT-III and "AIR BAG" warning lamp. Refer to See: Restraints and Safety Systems\Air Bag Systems\Testing and Inspection\Component Tests and General Diagnostics for details. Make sure entire SRS operates properly.
4. After the work is completed, perform self-diagnosis to check that no malfunction is detected. Refer to See: Restraints and Safety Systems\Air Bag Systems\Testing and Inspection\Scan Tool Testing and Procedures\On Board Diagnostic (OBD) System\Self-Diagnosis Function (Without CONSULT-III).

SRS INSPECTION (FOR SIDE AND ROLLOVER COLLISION)