ALTIMA SEDAN, COUPE, AND HYBRID; ENGINE NO CRANK / NO START
APPLIED VEHICLES 2007 - 2010 Altima Sedan (L32) with CVT only
2008 - 2010 Altima Coupe (CL32) with CVT only
2007 - 2010 Altima Hybrid (L32HV)
IF YOU CONFIRM:
The engine will not crank (or go to READY MODE - Hybrid) when pressing the push-button ignition switch and applying the brake pedal.
ACCESSORY and IGNITION ON modes can be turned on and off during this condition.
ACTION:
Install a new brake lamp switch and sub-harness with those listed in PARTS INFORMATION.
For parts replacement and installation, refer to SERVICE PROCEDURE.
NOTE:
^
This bulletin does not apply to manual transmission equipped vehicles.
^
This bulletin does not apply to Hybrid vehicles with HEV related CONSULT-III DTCs.
^
This bulletin does not apply for this incident, should it occur, if ACCESSORY and IGNITION ON modes cannot be turned on.
>
Go back to ASIST and the Electronic Service Manual (ESM) for further diagnostic and repair information.
IMPORTANT:
The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair.
