B2618 BCM

Description
BCM controls the various electrical components and simultaneously supplies power according to the power supply position.
BCM checks the power supply position internally.

DTC Logic

DTC DETECTION LOGIC

NOTE:

• If DTC B2618 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to See: U Code Charts\U1000\Power Distribution System.
• If DTC B2618 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to See: U Code Charts\U1010\Power Distribution System.

1. PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON under the following conditions, and wait for at least 1 second.

• CVT selector lever is in the P or N position
• Release brake pedal

2. Check "Self diagnostic result" with CONSULT-III. Is DTC detected?

YES >> Go to Diagnosis Procedure.
NO >> Inspection End.

Diagnosis Procedure

1. Inspection START

1. Turn ignition switch ON.
2. Select "Self diagnostic result" mode with CONSULT-III.
3. Touch "ERASE".
4. Perform DTC Confirmation Procedure. See DTC Logic.

Is the 1st trip DTC B2618 displayed again?
YES >> Replace BCM. Refer to See: Body and Frame\Body Control Systems\Body Control Module\Service and Repair.
NO >> Inspection End.