Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » A L L Diagnostic Trouble Codes ( DTC ) » Testing and Inspection » Related Tests, Information and Procedures » Diagnostic Procedure 3  
 
 
  Diagnostic Procedure 3  
 

ON BOARD DIAGNOSTIC (OBD) SYSTEM

Self-Diagnosis Function (Without CONSULT-III)

HOW TO CHANGE SELF-DIAGNOSIS MODE

  

DIAGNOSTIC PROCEDURE 3

Final Check of SRS Using CONSULT-III--Diagnosis Mode

  1. Connect CONSULT-III.
  2. If no DTC is detected on "SELF-DIAG [CURRENT]", repair of SRS is completed. Go to step 3. If any DTC is detected on "SELF-DIAG [CURRENT]", the malfunctioning part has not been repaired completely or another malfunctioning part is being detected. Perform DIAGNOSTIC PROCEDURE 2. Refer to See: Restraints and Safety Systems\Air Bag Systems\Testing and Inspection\Component Tests and General Diagnostics\Diagnostic Procedure 1.
  3. Touch "ERASE".

NOTE:
Touch "ERASE" to clear the memory of the malfunction ("SELF-DIAG [PAST]").
If the memory of the malfunction in "SELF-DIAG [PAST]" is not erased, the User mode shows the system malfunction by the operation of the warning lamp even if the malfunction is repaired completely.

  1. Touch "BACK" key of CONSULT-III. Touch "SELF-DIAG [PAST]".
  2. Check that no malfunction is detected on "SELF-DIAG [PAST]".
  3. Touch "BACK" key of CONSULT-III to return to User mode from Diagnosis mode.
  4. Turn ignition switch OFF and then turn off and disconnect CONSULT-III.
  5. Go to See: Restraints and Safety Systems\Air Bag Systems\Testing and Inspection\Component Tests and General Diagnostics\Diagnostic Procedure 1.