DOOR LOCK

BACK DOOR LOCK : Removal and Installation

REMOVAL

1. Remove the rear door finisher. Refer to See: Doors, Hood and Trunk\Front Door Panel\Service and Repair\Removal and Installation\Sedan.

2. Disconnect the inside handle knob cable and lock knob cable from the back side of the inside door handle.
3. Remove the rear door sash. Refer to .
4. Remove the rear door window and rear door screen assembly.

5. Remove door side grommet, and remove outside handle escutcheon bolt (TORX T30) from grommet hole.

6. While pulling the outside handle, remove outside handle escutcheon.

7. While pulling outside handle, slide toward rear of vehicle to remove outside handle.

8. Remove the front gasket and rear gasket.

9. Remove the TORX bolts (T30), remove the door lock assembly.

10. Remove the TORX bolt (T30) (A) from the outside handle bracket.

11. While pulling outside handle, slide toward rear of vehicle to remove outside handle.
12. Disconnect the door lock actuator connector and remove the door lock assembly.

13. Disconnect the outside handle cable from the outside handle bracket.

INSTALLATION
Installation is in the reverse order of removal.