Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » A L L Diagnostic Trouble Codes ( DTC ) » Testing and Inspection » B Code Charts » B2617 » Sedan Without Intelligent Key  
 
 
  Sedan Without Intelligent Key  
 

B2617 STARTER RELAY CIRCUIT

Description
Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication.

DTC Logic

DTC DETECTION LOGIC

NOTE:

  

DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON under the following conditions and wait for at least 1 second.
    • CVT selector lever is in the P position.
    • Do not depress the brake pedal.
  1. Check "Self diagnostic result" with CONSULT-III. Is DTC detected?

YES >> Refer to Diagnosis Procedure.
NO >> Inspection End.

Diagnosis Procedure
1.CHECK STARTER RELAY

  1. Turn ignition switch ON.

  

  1. Check voltage between BCM harness connector and ground under the following condition.

  

Is the measurement value within the specification.
YES >> GO TO 3
NO >> GO TO 2
2.CHECK STARTER RELAY CIRCUIT

  1. Turn ignition switch OFF.
  2. Disconnect BCM harness connector and IPDM E/R harness connector.

  

  1. Check continuity between IPDM E/R harness connector and BCM harness connector.

  

  1. Check continuity between IPDM E/R harness connector and ground.

  

Is the Inspection result normal?
YES >> Replace BCM. Refer to See: Body and Frame\Body Control Systems\Body Control Module\Service and Repair.
NO >> Repair harness or connector.
3.CHECK INTERMITTENT INCIDENT
Refer to See: Testing and Inspection\Initial Inspection and Diagnostic Overview\Service Information For Electrical Incident\Intermittent Incident.
>> Inspection End.