The selector lever cannot be shifted from "P" position to any other position unless the ignition switch is in the
ON position and the brake pedal is depressed.
SHIFT LOCK SYSTEM
Diagnosis Procedure
CHECK POWER SOURCE
Disconnect CVT device connector.
Turn ignition switch ON.
Check voltage between CVT device connector M23 terminal 6 and ground.
Is the Inspection result normal?
YES >> GO TO 5.
NO >> GO TO 2.
CHECK POWER SOURCE AT STOP LAMP SWITCH
Turn ignition switch OFF.
Disconnect stop lamp switch connector.
Turn ignition switch ON.
Check voltage between stop lamp switch connector E38 terminal 3 and ground.
Is the Inspection result normal?
YES >> GO TO 3.
NO >> Check the following:
Harness for short or open between fuse block (J/B) and stop lamp switch
10A fuse [No. 3, located in fuse block (J/B)]
CHECK STOP LAMP SWITCH
Turn ignition switch OFF.
Check continuity between stop lamp switch terminals 3 and 4.