Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » Sensors and Switches » Sensors and Switches - Powertrain Management » Sensors and Switches - Computers and Control Systems » Accelerator Pedal Position Sensor » Service and Repair » Removal and Installation  
 
 
  Removal and Installation  
 

ACCELERATOR CONTROL SYSTEM

Removal and Installation

REMOVAL

  1. Disconnect the battery negative terminal.
  2. Disconnect the accelerator position sensor electrical connector.
  3. Remove the three accelerator pedal nuts.
  4. Remove the accelerator pedal and accelerator position sensor assembly.

CAUTION:

  • Do not disassemble the pedal assembly. Do not remove the accelerator pedal position sensor from the pedal assembly.
  • Avoid impact from dropping during handling.
  • Keep the pedal assembly away from water.

INSTALLATION
Installation is in the reverse order of removal.

  • Align and install accelerator pedal and accelerator position sensor assembly with locating pins in locating pin holes.
  • Check the accelerator pedal for smooth operation. There should be no binding or sticking when applying or releasing the accelerator pedal.

  

  • Check that the accelerator pedal moves through the full specified distance of pedal travel.

Pedal travel (A) : 48.5 - 53.5 mm (1.91 - 2.11 in)

CAUTION:

When the harness connector of the accelerator pedal position sensor is disconnected, perform the "Accelerator pedal released position learning". Refer to , (QR25DE except for California), See: Testing and Inspection\Special Repair Requirement (VQ35DE).