Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » Body and Frame » Technical Service Bulletins » Customer Interest » Interior - Driver's Seat Side To Side Movement » Service Procedure » Information  
 
 
  Information  
 

  

1. Write down the radio station presets.

2. Slide the driver's seat fully rearward and remove the front two seat-to-body bolts.

3. Remove the headrest, tilt the seat back to the upright position and tilt the seat cushion fully up in the front and in the back.

IMPORTANT:
Make sure the seat cushion is tilted into

^ the fully UP position in BACK

and

^ the fully UP position in FRONT.

NOTE:
It will be easier to do the procedure if the cushion is in this position.

4. Slide the seat mid-travel and remove the rear seat-to-body bolts.

5. Disconnect both 12V battery cables, negative cable first, and wait at least 3 minutes before proceeding to step 6.

6. Disconnect the seat harnesses from the body harnesses.

7. Remove the seat from the vehicle.

8. Place the seat, back side down, on a clean covered workbench.

9. Determine which seat type you have:

  

^ If you have a seat with a tube ring on the left side and a tube ring on the right side, go to Service Procedure A (seat frame needed) in this bulletin.

  

^ If you have a seat with both tube rings on the same side as shown in Figure 3, go to Service Procedure B (seat frame not needed) in this bulletin.