B210E STARTER RELAY

Description
Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication.

DTC Logic

DTC DETECTION LOGIC

NOTE:

• If DTC B210E is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to See: U Code Charts\U1000\Security System\Sedan With Intelligent Key.
• If DTC B210E is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to See: U Code Charts\U1010\Security System\Sedan With Intelligent Key.

1. Turn ignition switch ON under the following conditions and wait for at least 1 second.

• CVT selector lever is in the P or N position
• Do not depress the brake pedal

2. Check "Self diagnostic result" with CONSULT-III. Is DTC detected?

YES >> Refer to Diagnosis Procedure.
NO >> Inspection End.

Diagnosis Procedure
1.Inspection START
Check which type of transmission the vehicle is equipped with.
Which type of transmission
CVT >> GO TO 2
M/T >> GO TO 3
2.CHECK STARTER RELAY OUTPUT SIGNAL/CVT MODELS

1. Turn ignition switch OFF.
2. Disconnect BCM harness connector.

3. Check voltage between BCM harness connector and ground.

1. Turn ignition switch OFF.
2. Disconnect BCM harness connector.

3. Check voltage between BCM harness connector and ground.

1. Disconnect IPDM E/R harness connector.

2. Check continuity between IPDM E/R harness connector and BCM harness connector.

3. Check continuity between BCM harness connector and ground.

1. Turn ignition switch OFF.
2. Disconnect IPDM E/R harness connector.

3. Check voltage between IPDM E/R harness connector and ground.