Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » A L L Diagnostic Trouble Codes ( DTC ) » Testing and Inspection » B Code Charts » B210F » Sedan Without Intelligent Key  
 
 
  Sedan Without Intelligent Key  
 

B210F PNP/CLUTCH INTERLOCK SWITCH

Description
IPDM E/R confirms the shift position with the following signals.

  • Park/neutral position (PNP) switch
  • Shift position signal from BCM (CAN)

DTC Logic

DTC DETECTION LOGIC

NOTE:

  

DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON under the following conditions and wait for at least 1 second.
    • CVT selector lever is in the P or N position
    • Do not depress the brake pedal
  1. Check "Self diagnostic result" with CONSULT-III. Is DTC detected?

YES >> Refer to Diagnosis Procedure.
NO >> Inspection End.

Diagnosis Procedure
1.CHECK DTC WITH BCM
Refer to See: Testing and Inspection.
Is the Inspection result normal?
YES >> GO TO 2
NO >> Repair or replace malfunctioning parts.
2.CHECK PNP SWITCH INPUT SIGNAL

  1. Turn ignition switch OFF.
  2. Disconnect IPDM E/R harness connector.
  3. Turn ignition switch ON.

  

  1. Check voltage between IPDM E/R harness connector and ground under following condition.

  

Is the Inspection result normal?
YES >> Replace IPDM E/R. Refer to See: Power and Ground Distribution\Power Distribution Module\Service and Repair.
NO >> GO TO 3
3.CHECK PNP SWITCH CIRCUIT FOR CONTINUITY

  1. Turn ignition switch OFF.

  

  1. Check continuity between IPDM E/R harness connector terminals 72 and 74.

  

Is the Inspection result normal?
YES >> GO TO 4
NO >> GO TO 5
4.CHECK PNP SWITCH CIRCUIT FOR SHORT

  

Check continuity between IPDM E/R harness connector terminals
72, 74 and ground.

  

Is the Inspection result normal?
YES >> Replace the IPDM E/R. Refer to See: Power and Ground Distribution\Power Distribution Module\Service and Repair.
NO >> Repair or replace harness.
5.CHECK PNP SWITCH INPUT SIGNAL CIRCUIT

  1. Disconnect PNP switch harness connector.

  

  1. Check continuity between PNP switch and IPDM E/R harness connectors.

  

  1. Check continuity between PNP switch harness connector and ground.

  

Is the Inspection result normal?
YES >> Replace PNP switch.
NO >> Repair harness or connector.