WHEEL SENSORS

Removal and Installation

• Be careful not to damage wheel sensor edge and sensor rotor teeth.
• When removing the front or rear wheel hub, first remove the wheel sensor from the wheel hub. Failure to do so may result in damage to the wheel sensor wires making the sensor inoperative.
• Pull out the wheel sensor, being careful to turn it as little as possible. Do not pull on the wheel sensor harness.
• Before installation, check if foreign objects such as iron fragments are adhered to the pick-up part of the sensor or to the inside of the hole in the wheel hub for the wheel sensor, or if a foreign object is caught in the surface of the mating surface for the sensor rotor. Fix as necessary and then install the wheel sensor.

FRONT WHEEL SENSOR

Removal

1. Remove front wheel and tire. Refer to See: Maintenance\Wheels and Tires\Service and Repair.
2. Partially front wheel fender protector. Refer to See: Body and Frame\Fender\Front Fender\Front Fender Liner\Service and Repair\Coupe.
3. Remove wheel sensor bolt and wheel sensor.
4. Remove harness wire from mounts and disconnect wheel sensor harness connector.

Installation
Installation is in the reverse order of removal.

REAR WHEEL SENSOR

NOTE:
Both rear wheel sensors share one harness and must be replaced as an assembly.

Removal

1. Remove rear wheel and tire. Refer to See: Maintenance\Wheels and Tires\Service and Repair.
2. Remove wheel sensor bolts and wheel sensors from both rear wheel hub and bearing assemblies.
3. Remove harness wire from mounts and harness wire clips from rear suspension member.

4. Disconnect wheel sensor harness connector (1).

• Arrow Indicates Front

Installation
Installation is in the reverse order of removal.