Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » Brakes and Traction Control » Parking Brake System » Parking Brake Control » Service and Repair » Pedal Type » Removal And Installation  
 
 
  Removal And Installation  
 

PARKING BRAKE CONTROL

PEDAL TYPE : Removal and Installation

REMOVAL

  1. Remove rear wheel and tires. Refer to See: Maintenance\Wheels and Tires\Service and Repair.
  2. Remove instrument lower cover and lower knee protector. Refer to See: Body and Frame\Interior Moulding / Trim\Dashboard / Instrument Panel\Service and Repair\Exploded View.
  3. Disconnect parking brake switch connector.
  4. Remove adjusting nut and discard, then loosen front cable.

CAUTION:
Do not reuse adjusting nut.

  1. Remove control device assembly nuts and remove control device assembly.
  2. Remove center console. Refer to See: Body and Frame\Interior Moulding / Trim\Dashboard / Instrument Panel\Service and Repair\Exploded View.
  3. Separate rear cables from front cable, remove front cable.
  4. Remove heat insulator of the exhaust center tube.
  5. Remove parking brake shoe, and remove rear cables from toggle lever. Refer to See: Body and Frame\Interior Moulding / Trim\Dashboard / Instrument Panel\Service and Repair\Exploded View.
  6. Remove rear cable bolts and nuts, then remove rear cables.

INSTALLATION
Installation is in the reverse order of removal.

CAUTION:
Do not reuse adjusting nut.