Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » Accessories and Optional Equipment » Collision Avoidance and Parking Assist Systems » Testing and Inspection » Component Tests and General Diagnostics » Power Supply And Ground Circuit (Coupe) » Rear View Camera  
 
 
  Rear View Camera  
 

POWER SUPPLY AND GROUND CIRCUIT (COUPE)

REAR VIEW CAMERA : Diagnosis Procedure

1.CHECK POWER SUPPLY CIRCUIT (REAR VIEW CAMERA SIDE)

  

Check voltage between rear view camera harness connector and ground.

  

Is voltage reading approximately 6 volts?
YES >> GO TO 4
NO >> GO TO 2
2.CHECK POWER SUPPLY CIRCUIT (CONTINUITY)

  1. Turn ignition switch OFF.
  2. Disconnect rear view camera and rear view camera control unit connectors.

  

  1. Check continuity between rear view camera harness connector T7 (A) terminal 1 and rear view camera control unit harness connector B31 (B) terminal 8.

  

  1. Check continuity between rear view camera harness connector T7 (A) terminal 1 and ground.

  

Are continuity test results as specified?
YES >> GO TO 3
NO >> Repair harness or connector.
3.CHECK POWER SUPPLY CIRCUIT (CAMERA CONTROL UNIT SIDE)

  1. Connect rear view camera control unit harness connector.
  2. Turn ignition switch ON.

  

  1. Check voltage between rear view camera control unit harness connector and ground.

  

Is voltage reading approximately 6 volts?
YES >> Inspection End.
NO >> Replace rear view camera control unit. Refer to See: Parking Assist Control Module\Service and Repair\Removal And Installation - Coupe.
4.CHECK GROUND CIRCUIT

  1. Turn ignition switch OFF.
  2. Disconnect rear view camera harness connector.

  

  1. Check continuity between rear view camera harness connector B35 terminal 2 and ground.

  

Does continuity exist?
YES >> Inspection End.
NO >> Repair harness or connector.