CAMERA ON SIGNAL CIRCUIT (SEDAN)
Description
When the selector lever is placed in the R position, the rear view camera control unit sends a camera ON signal to the rear view camera.
CAMERA ON SIGNAL CIRCUIT (SEDAN)
Diagnosis Procedure
1.CHECK CAMERA ON SIGNAL CIRCUIT CONTINUITY
- Turn ignition switch OFF.
- Disconnect rear view camera control unit connector and rear view camera connector.
- Check continuity between rear view camera control unit harness connector B31 (A) terminal 8 and rear view camera harness connector B35 (B) terminal 1.
8 - 1 : Continuity should exist.
- Check continuity between rear view camera control unit harness connector B31 (B) terminal 8 and ground.
8 - Ground : Continuity should not exist.
Is Inspection result OK?
YES >> GO TO 2
NO >> Repair harness or connector.
2.CHECK CAMERA ON SIGNAL VOLTAGE
- Connect rear view camera control unit connector and rear view camera connector.
- Turn ignition switch ON.
- Check voltage between rear view camera control unit harness connector B31 terminal 8 and ground.
8 - Ground : Approx. 6 V
Is Inspection result OK?
YES >> Replace rear view camera. Refer to See: Rear Vision Camera\Service and Repair.
NO >> Replace rear view camera control unit. Refer to See: Parking Assist Control Module\Service and Repair\Removal And Installation - Sedan.
|