FLOOR TRIM
Removal and Installation
REMOVAL
- Remove front seat (RH/LH) and rear seat cushion. Refer to See: Seats\Service and Repair\Removal and Replacement\Front Seat\Removal And Installation\Sedan and See: Seats\Service and Repair\Removal and Replacement\Rear Seat\Removal And Installation\Sedan.
- Remove lower body side trim. Refer to See: Trim Panel\Service and Repair\Removal And Installation\Sedan.
- Remove center console. Refer to See: Dashboard / Instrument Panel\Service and Repair\Removal And Installation.
- Remove the connector duct (RH/LH) (2) and the center connector duct (1) from heater and cooling unit. Refer to See: Heating and Air Conditioning\Air Duct\Service and Repair\Ducts, Nozzles And Grilles (Components).
- Arrow Indicates Vehicle front
- Remove the bracket bolt, then position the parking brake cable aside.
- Disconnect the drain hose (4) from the heater and cooling unit, then set aside.
- Remove the three bolts (A) and one nut, then remove the bracket (3).
- Remove the diagnosis sensor unit. Refer to See: Power and Ground Distribution\Auxiliary Power Outlet\Service and Repair.
- Remove the parking brake cable nuts (A), then position the parking brake cables (2) aside.
- Arrow Indicates Vehicle front
- Remove the bracket nuts (B), then remove extension bracket (1) and center console rear bracket (3).
- Remove front seat belt floor anchor bolt (RH/LH). Refer to See: Restraints and Safety Systems\Seat Belt Systems\Seat Belt\Service and Repair\Removal and Replacement\Front Seat Belt\Removal And Installation.
- Release the tab, then remove floor mat hook.
- Release the tabs and open harness clamps (seven-R/H and seven-L/H). Position harness and floor carpet cut-out areas outside of harness clamps.
- Fold corners toward center, then remove floor carpet.
INSTALLATION
Installation is in the reverse order of removal.
|