Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » A L L Diagnostic Trouble Codes ( DTC ) » Testing and Inspection » C Code Charts » C1708  
 
 
  C1708  
 

C1708 - C1711 DATA FROM TRANSMITTER NOT BEING RECEIVED

Description
Tire pressure data for one or more transmitters is not being received by the BCM.

DTC Logic

DTC DETECTION LOGIC

  

DTC CONFIRMATION PROCEDURE
1.ID REGISTRATION AND VEHICLE DRIVING

  1. Carry out ID registration of all transmitters.
  2. Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for 10 minutes.
  3. Check all tire pressures with CONSULT-III within 5 minutes. Does DATA MONITOR ITEM display tire pressure as normal without any warning lamp?

YES >> Inspection End.
NO >> Refer to Diagnosis Procedure.

Diagnosis Procedure

MALFUNCTION CODE NO. 21, 22, 23 OR 24 (DTC C1708, C1709, C1710 OR C1711)
1.CHECK BCM
Drive for several minutes. Check all tire pressures with CONSULT-III.
Are all tire pressures displayed as 0 kPa?
YES >> GO TO 2
NO >> GO TO 3
2.CHECK TIRE PRESSURE RECEIVER CONNECTOR
Check tire pressure receiver connector for damage or loose connections.
Is tire pressure receiver connector damaged or loose?
YES >> Repair or replace tire pressure receiver connector.
NO >> Replace BCM, then GO TO 3. Refer to See: Body and Frame\Body Control Systems\Body Control Module\Service and Repair.
3.PERFORM ID REGISTRATION
Carry out ID registration of all transmitters. Refer to See: Instrument Panel, Gauges and Warning Indicators\Tire Monitoring System\Testing and Inspection\Programming and Relearning\ID Registration Procedure.
Is there a tire that cannot register ID?
YES >> Replace malfunctioning transmitter, then GO TO 5. Refer to See: Instrument Panel, Gauges and Warning Indicators\Tire Pressure Sensor\Service and Repair.
NO >> GO TO 4
4.DRIVE VEHICLE

  1. Drive at a speed of 40 km/h (25 MPH) or more for several minutes without stopping.
  2. Check all tire pressures with CONSULT-III within 15 minutes after vehicle speed becomes 17 km/h (11 MPH). Does "DATA MONITOR ITEM" display tire pressure as normal without any warning lamp?

YES >> Inspection End.
NO >> GO TO 5
5.ID REGISTRATION AND VEHICLE DRIVING

  1. Carry out ID registration of all transmitters.
  2. Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for 10 minutes.
  3. Check all tire pressures with CONSULT-III within 5 minutes. Does "DATA MONITOR ITEM" display tire pressure as normal without any warning lamp?

YES >> Inspection End.
NO >> Proceed to the Inspection applicable to DTC.

Special Repair Requirement
Perform preliminary check. Refer to See: Instrument Panel, Gauges and Warning Indicators\Tire Monitoring System\Testing and Inspection\Initial Inspection and Diagnostic Overview\Preliminary Check.