The EVAP control system pressure sensor detects pressure in the purge line. The sensor output voltage to the ECM increases as pressure increases.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test.
Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON.
Turn ignition switch OFF and wait at least 10 seconds. >> GO TO 2.
2.PERFORM DTC CONFIRMATION PROCEDURE
Start engine and wait at least 40 seconds.
NOTE: Do not depress accelerator pedal even slightly.
Check 1st trip DTC. Is 1st trip DTC detected?
YES >> Go to Diagnosis Procedure.
NO >> Inspection END
YES >> GO TO 2.
NO >> Repair or replace ground connection. 2.CHECK EVAP CONTROL SYSTEM PRESSURE SENSOR CONNECTOR FOR WATER
Disconnect EVAP control system pressure sensor harness connector.
Check that water is not inside connectors. Is the Inspection result normal?
YES >> GO TO 3.
NO >> Repair or replace harness connector. 3.CHECK EVAP CONTROL SYSTEM PRESSURE SENSOR POWER SUPPLY CIRCUIT
Turn ignition switch ON.
Check the voltage between EVAP control system pressure sensor harness connector and ground.
Is the Inspection result normal?
YES >> GO TO 8.
NO >> GO TO 4. 4.CHECK SENSOR POWER SUPPLY CIRCUIT
Check harness for short to power and short to ground, between the following terminals.
Is the Inspection result normal?
YES >> GO TO 5.
NO >> Repair short to ground or short to power in harness or connectors. 5.CHECK COMPONENTS
Check the following.
Crankshaft position sensor (POS) (Refer to See: P0335.)
YES >> GO TO 6.
NO >> Replace malfunctioning components. 6.CHECK APP SENSOR
Refer to See: P2122.
Is the Inspection result normal?
YES >> GO TO 9.
NO >> GO TO 7. 7.REPLACE ACCELERATOR PEDAL ASSEMBLY