Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » A L L Diagnostic Trouble Codes ( DTC ) » Testing and Inspection » P Code Charts » P0605  
 
 
  P0605  
 

P0605 ECM

Description

  

The ECM consists of a microcomputer and connectors for signal input and output and for power supply. The ECM controls the engine.

DTC Logic

DTC DETECTION LOGIC

  

DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds. >> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION A

  1. Turn ignition switch ON.
  2. Check 1st trip DTC. Is 1st trip DTC detected?

YES >> Go to Diagnosis Procedure.
NO >> GO TO 3.
3.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION B

  1. Turn ignition switch ON and wait at least 1 second.
  2. Turn ignition switch OFF, wait at least 10 seconds, and then turn it ON.
  3. Check 1st trip DTC. Is 1st trip DTC detected?

YES >> Go to Diagnosis Procedure.
NO >> GO TO 4.
4.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION C

  1. Turn ignition switch ON and wait at least 1 second.
  2. Turn ignition switch OFF, wait at least 10 seconds, and then turn it ON.
  3. Repeat step 2 for 32 times.
  4. Check 1st trip DTC. Is 1st trip DTC detected?

YES >> Go to Diagnosis Procedure.
NO >> Inspection END

Diagnosis Procedure
1.Inspection START

  1. Turn ignition switch ON.
  2. Erase DTC.
  3. Perform DTC CONFIRMATION PROCEDURE. See DTC Logic.

Is the 1st trip DTC P0605 displayed again?
YES >> GO TO 2.
NO >> Inspection END
2.REPLACE ECM

  1. Replace ECM.
  2. Go to See: Powertrain Management\Computers and Control Systems\Testing and Inspection\Programming and Relearning\Additional Service When Replacing Control Unit\Special Repair Requirement. >> Inspection END