Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » Engine, Cooling and Exhaust » Engine » Valve Cover » Service and Repair » Removal And Installation RH  
 
 
  Removal And Installation RH  
 

ROCKER COVER

Removal and Installation RH

REMOVAL

  1. Remove the engine cover, using power tool.
  2. Disconnect the mass air flow sensor electrical connector and remove the air cleaner assembly and air intake tubes. Refer to See: Air Cleaner Fresh Air Duct/Hose\Service and Repair.
  3. Remove the intake manifold collector using power tool. Remove gasket and the electric throttle control actuator. Refer to See: Intake Manifold\Service and Repair\Intake Manifold Collector.
  4. Remove ignition coils. Refer to See: Powertrain Management\Ignition System\Ignition Coil\Service and Repair\Removal And Installation RH.

CAUTION:
Never shock ignition coils.

  

  1. Remove camshaft position sensor.

CAUTION:

  • Handle carefully to avoid dropping and shocks.
  • Do not disassemble.
  • Do not allow metal powder to adhere to magnetic part at sensor tip (A).
  • Do not place sensors in a location where they are exposed to magnetism.

  

  1. Remove RH rocker cover bolts from cylinder head as shown.

Arrow Indicates Front

INSTALLATION
Installation is in the reverse order of removal.

Tool number : WS39930000 ( - )

  

  • Tighten the rocker cover bolts in two steps in the order as shown.

Arrow Indicates Front