Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » Transmission and Drivetrain » Clutch » Clutch Master Cylinder » Service and Repair  
 
 
  Service and Repair  
 

CLUTCH MASTER CYLINDER

Removal and Installation

REMOVAL

  1. Remove the air cleaner and air duct. Refer to See: Engine, Cooling and Exhaust\Engine\Air Filter Element\Service and Repair for QR25DE and See: Engine, Cooling and Exhaust\Engine\Air Filter Element\Service and Repair for VQ35DE.
  2. Use one of the following methods to remove hose from master cylinder.
    • Drain clutch fluid from reservoir tank and remove hose.
    • Remove hose from master cylinder. Immediately plug hose and reservoir tank to prevent clutch fluid from dripping.

CAUTION:
Do not spill clutch fluid onto painted surfaces. If it spills, wipe up immediately and wash the affected area with water.

  

  1. Remove master cylinder rod end from clutch pedal assembly.
  2. Remove lock pin (1) from connector of master cylinder (2) and separate clutch tube (3).

  

  1. Rotate master cylinder clockwise by 45° and remove from the vehicle.

INSTALLATION

  1. Tilt master cylinder clockwise by 45° and insert it in the mounting hole. Rotate counterclockwise to secure it. At this time, nipple is in the up position.

  

  1. Install master cylinder rod end to clutch pedal.
  2. Install clutch tube (1) fully into connector of master cylinder (2).

  

  1. Install lock pin (3) fully into connector of master cylinder (2).
  2. Fill with new clutch fluid and bleed clutch hydraulic system. Refer to See: Clutch Pedal Assembly\Adjustments.
  3. Inspect clutch pedal operation. Refer to See: Clutch Pedal Assembly\Adjustments.
  4. Install the air cleaner and air duct. Refer to See: Engine, Cooling and Exhaust\Engine\Air Filter Element\Service and Repair for QR25DE and See: Engine, Cooling and Exhaust\Engine\Air Filter Element\Service and Repair for VQ35DE.