STEERING ANGLE SENSOR
Removal and Installation
CAUTION:
In the case that the ABS actuator and electronic unit (control unit) is replaced, make sure to adjust position of steering angle sensor. Refer to See: Antilock Brakes / Traction Control Systems\Testing and Inspection\Programming and Relearning\Description See: Antilock Brakes / Traction Control Systems\Testing and Inspection\Programming and Relearning\Special Repair Requirement See: Testing and Inspection\Description See: Testing and Inspection\Special Repair Requirement.
REMOVAL
- Remove the spiral cable. Refer to See: Restraints and Safety Systems\Air Bag Systems\Clockspring Assembly / Spiral Cable\Service and Repair.
- Remove the two screws (A) and release the three clips (B) to remove the steering angle sensor (1) from spiral cable (2).
INSTALLATION
Installation is in the reverse order of removal.
|
