Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » Steering and Suspension » Steering » Power Steering Fluid » Service and Repair » Checking Fluid Level  
 
 
  Checking Fluid Level  
 

POWER STEERING FLUID

Inspection

FLUID LEVEL

  • Check fluid level with engine stopped.

  

  • Make sure that fluid level is between MIN and MAX.
  • Fluid levels at HOT (A) and COLD (B) are different. Do not confuse them.

  

CAUTION:

  • The fluid level should not exceed the MAX line. Excessive fluid will cause fluid leakage from the cap.
  • Do not reuse drained power steering fluid.
  • Recommended fluid is Genuine Nissan PSF or equivalent.

FLUID LEAKAGE
Check hydraulic connections for fluid leakage, cracks, damage, looseness, or wear.

  

  1. Run engine until the fluid temperature reaches 50 to 80° C (122 to 176°F) in reservoir tank, and keep engine speed idle.
  2. Turn steering wheel several times from full left stop to full right stop.
  3. Hold steering wheel at each lock position for five seconds and carefully, check for fluid leakage.

CAUTION:
Do not hold the steering wheel in a locked position for more than 10 seconds. (There is the possibility that oil pump may be damaged.)

  1. If fluid leakage at connections is noticed, then loosen flare nut and then retighten. Do not overtighten connector as this can damage O-ring, washer and connector.
  2. If fluid leakage from oil pump is noticed, check oil pump. Refer to See: Power Steering Pump\Service and Repair\Removal and Replacement (QR25DE), See: Power Steering Pump\Service and Repair\Removal and Replacement (VQ35DE).
  3. Check steering gear boots for accumulation of fluid indicating from steering gear.