2. Slide the driver's seat fully rearward and remove the front two seat-to-body bolts.
3. Remove the headrest, tilt the seat back to the upright position and tilt the seat cushion fully up in the front and in the back.
IMPORTANT:
Make sure the seat cushion is tilted into
^
the fully UP position in BACK
and
^
the fully UP position in FRONT.
NOTE:
It will be easier to do the procedure if the cushion is in this position.
4. Slide the seat mid-travel and remove the rear seat-to-body bolts.
5. Disconnect both 12V battery cables, negative cable first, and wait at least 3 minutes before proceeding to step 6.
6. Disconnect the seat harnesses from the body harnesses.
7. Remove the seat from the vehicle.
8. Place the seat, back side down, on a clean covered workbench.
9. Determine which seat type you have:
^
If you have a seat with a tube ring on the left side and a tube ring on the right side, go to Service Procedure A (seat frame needed) in this bulletin.
^
If you have a seat with both tube rings on the same side as shown in Figure 3, go to Service Procedure B (seat frame not needed) in this bulletin.
