FLOOR TRIM

Removal and Installation

REMOVAL

1. Remove front seat (RH/LH) and rear seat cushion. Refer to See: Seats\Service and Repair\Removal and Replacement\Front Seat\Removal And Installation\Sedan and See: Seats\Service and Repair\Removal and Replacement\Rear Seat\Removal And Installation\Sedan.
2. Remove lower body side trim. Refer to See: Trim Panel\Service and Repair\Removal And Installation\Sedan.
3. Remove center console. Refer to See: Dashboard / Instrument Panel\Service and Repair\Removal And Installation.

4. Remove the connector duct (RH/LH) (2) and the center connector duct (1) from heater and cooling unit. Refer to See: Heating and Air Conditioning\Air Duct\Service and Repair\Ducts, Nozzles And Grilles (Components).

• Arrow Indicates Vehicle front

5. Remove the bracket bolt, then position the parking brake cable aside.
6. Disconnect the drain hose (4) from the heater and cooling unit, then set aside.
7. Remove the three bolts (A) and one nut, then remove the bracket (3).
8. Remove the diagnosis sensor unit. Refer to See: Power and Ground Distribution\Auxiliary Power Outlet\Service and Repair.

9. Remove the parking brake cable nuts (A), then position the parking brake cables (2) aside.

• Arrow Indicates Vehicle front

10. Remove the bracket nuts (B), then remove extension bracket (1) and center console rear bracket (3).
11. Remove front seat belt floor anchor bolt (RH/LH). Refer to See: Restraints and Safety Systems\Seat Belt Systems\Seat Belt\Service and Repair\Removal and Replacement\Front Seat Belt\Removal And Installation.
12. Release the tab, then remove floor mat hook.
13. Release the tabs and open harness clamps (seven-R/H and seven-L/H). Position harness and floor carpet cut-out areas outside of harness clamps.
14. Fold corners toward center, then remove floor carpet.

INSTALLATION
Installation is in the reverse order of removal.