Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » Maintenance » Wheels and Tires » Wheel Hub » Service and Repair » Rear Wheel Hub  
 
 
  Rear Wheel Hub  
 

WHEEL HUB

Removal and Installation

  

REMOVAL

CAUTION:
Wheel hub assembly does not require maintenance. If any of the following symptoms are noted, replace the wheel hub assembly.

  • A growling noise is emitted from the wheel hub assembly while driving.
  • The wheel hub assembly drags or turns roughly.
  1. Remove the rear wheel and tire. Refer to See: Service and Repair.
  2. Remove the brake caliper assembly using power tool.
    • The brake hose does not need to be disconnected from the brake caliper.
    • Suspend the brake caliper assembly using wire, do not stretch the brake hose.
    • Do not depress the brake pedal, or the caliper piston will pop out.
    • Do not twist the brake hose.
  1. Remove the brake rotor.
  2. Remove the rear ABS sensor, then move it away from the wheel hub assembly.

CAUTION:
Failure to remove the ABS sensor may result in damage to the sensor wires and the sensor being inoperative.

  1. Remove the wheel hub assembly from knuckle.

Inspection AFTER REMOVAL
Check for any deformity, cracks, or damage on the wheel hub assembly, replace if necessary.

INSTALLATION
Installation is in the reverse order of removal.

  

  • Check that the wheel hub bearing axial end play is within specification.

Axial end play : 0.1 mm (0.004 in) or less