Electric throttle control actuator consists of throttle control motor, throttle position sensor, etc.
The throttle control motor is operated by the ECM and it opens and closes the throttle valve.
The current opening angle of the throttle valve is detected by the throttle position sensor. The throttle position sensor provides feedback to the ECM, when opens/closes the throttle valve in response to driving conditions via the throttle control motor.
DTC DETECTION LOGIC
NOTE: If DTC P2101 is displayed with DTC P2100, first perform the trouble diagnosis for DTC P2100. Refer to See: P2100. If DTC P2101 is displayed with DTC 2119, first perform the trouble diagnosis for DTC P2119. Refer to See: P2119.
DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test.
Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON.
Turn ignition switch OFF and wait at least 10 seconds. TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 11 V when engine is running.
>> GO TO 2. 2.PERFORM DTC CONFIRMATION PROCEDURE
Turn ignition switch ON and wait at least 2 seconds.
Start engine and let it idle for 5 seconds.
Check DTC. Is DTC detected?
YES >> Go to Diagnosis Procedure.
NO >> Inspection END