ON BOARD DIAGNOSTIC (OBD) SYSTEM

Self-Diagnosis Function (Without CONSULT-III)

HOW TO CHANGE SELF-DIAGNOSIS MODE

1. Connect CONSULT-III.
2. If no DTC is detected on "SELF-DIAG [CURRENT]", repair of SRS is completed. Go to step 3. If any DTC is detected on "SELF-DIAG [CURRENT]", the malfunctioning part has not been repaired completely or another malfunctioning part is being detected. Perform DIAGNOSTIC PROCEDURE 2. Refer to See: Restraints and Safety Systems\Air Bag Systems\Testing and Inspection\Component Tests and General Diagnostics\Diagnostic Procedure 1.
3. Touch "ERASE".

NOTE:
Touch "ERASE" to clear the memory of the malfunction ("SELF-DIAG [PAST]").
If the memory of the malfunction in "SELF-DIAG [PAST]" is not erased, the User mode shows the system malfunction by the operation of the warning lamp even if the malfunction is repaired completely.

4. Touch "BACK" key of CONSULT-III. Touch "SELF-DIAG [PAST]".
5. Check that no malfunction is detected on "SELF-DIAG [PAST]".
6. Touch "BACK" key of CONSULT-III to return to User mode from Diagnosis mode.
7. Turn ignition switch OFF and then turn off and disconnect CONSULT-III.
8. Go to See: Restraints and Safety Systems\Air Bag Systems\Testing and Inspection\Component Tests and General Diagnostics\Diagnostic Procedure 1.