After completing ECM programming, the following steps are required before C-III plus will provide the final programming confirmation report:
| 1. |
Follow the C-III plus on-screen instructions to perform the following:
| ^ |
Throttle Valve Closed Position
|
| ^ |
Idle Air Volume Learn (IAVL)
NOTE :
| > |
Listed below are common conditions required for IAVL to complete.
|
| > |
If IAVL does not complete within a few minutes, a condition may be out of range.
|
| > |
Refer to the appropriate Electronic Service Manual (ESM) for specific conditions required for the vehicle you are working on.
| ^ |
Engine coolant temperature: 70 -105°C (158 - 221°F)
|
| ^ |
Battery voltage: More than 12.9V (At idle)
|
| ^ |
Selector lever: P or N
|
| ^ |
Electric load switch: OFF (Air conditioner, headlamp, rear window defogger)
|
| ^ |
Steering wheel: Neutral (Straight-ahead position)
|
| ^ |
Vehicle speed: Stopped
|
| ^ |
Transmission: Warmed up
|
|
|
| ^ |
Accelerator Pedal Close Position Learning
|
| ^ |
Erase DTCs
|
|
| 2. |
Verify the before and after part numbers are different (see Figure 21a).
|
| 3. |
Print a copy of this screen (Figure 21a) and attach it to the repair order.
|
| 4. |
Select Confirm.
|
| 5. |
Select Home and return to the C-III plus home screen.
|
| 6. |
Go to Verify VIN is Registered.
|
|
