Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » Starting and Charging » Charging System » Testing and Inspection » Component Tests and General Diagnostics » B Terminal Circuit  
 
 
  B Terminal Circuit  
 

B TERMINAL CIRCUIT

Description

The terminal "1" (B) circuit supplies power to charge the battery and operate the vehicles electrical system.

B TERMINAL CIRCUIT

Diagnosis Procedure

1.CHECK TERMINAL "1" CONNECTION

  1. Turn ignition switch OFF.
  2. Check if terminal "1" is clean and tight. Is the Inspection result normal?

YES >> GO TO 2
NO >> Repair terminal "1" connection. Confirm repair by performing complete Starting/Charging system test. Refer to Technical Service Bulletin.
2.CHECK TERMINAL "1" CIRCUIT

  

Check voltage between generator connector F6 terminal 1 and ground.

1 - ground Battery voltage

Is the Inspection result normal?
YES >> GO TO 3
NO >> Check harness for open between generator and fusible link.
3.CHECK TERMINAL "1" CONNECTION (VOLTAGE DROP TEST)

  

  1. Start engine, then engine running at idle and warm.
  2. Check voltage between battery positive terminal and generator connector F6 terminal 1.

1 - B+ Less than 0.2V

Is the Inspection result normal?
YES >> Terminal "1" circuit is normal. Refer to See: Initial Inspection and Diagnostic Overview\Work Flow.
NO >> Check harness between battery and generator for high resistance.