Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » Starting and Charging » Charging System » Testing and Inspection » Component Tests and General Diagnostics » L Terminal Circuit  
 
 
  L Terminal Circuit  
 

L TERMINAL CIRCUIT

Description

The terminal "2" (L) circuit controls the charge warning lamp. The charge warning lamp illuminates when the ignition switch is set to ON or START. When the generator is providing sufficient voltage with the engine running, the charge warning lamp will go off. If the charge warning lamp illuminates with the engine running, a malfunction is indicated.

L TERMINAL CIRCUIT

Diagnosis Procedure

1.CHECK CHARGE WARNING LAMP CIRCUIT CONNECTION
Check to see if generator connector F7 terminal 2 is clean and tight.
Is the connection secure?
YES >> GO TO 2
NO >> Repair the connection. Confirm repair by performing complete Starting/Charging system test. Refer to Technical Service Bulletin.
2.CHECK CHARGE WARNING LAMP CIRCUIT

  

  1. Disconnect generator connector F7.
  2. Apply ground to generator harness connector F7 terminal 2 with the ignition switch in the ON position.

Charge lamp should illuminate

Does it illuminate?
YES >> Check generator function. Refer to See: Initial Inspection and Diagnostic Overview\Work Flow.
NO >> GO TO 3
3.CHECK HARNESS CONTINUITY (OPEN CIRCUIT)

  

  1. Turn ignition switch OFF.
  2. Disconnect the generator connector F7.
  3. Disconnect the combination meter connector M24.
  4. Check continuity between generator harness connector F7 (A) terminal 2 and combination meter harness connector M24 (B) terminal 25.

  

Is continuity present?
YES >> Replace the combination meter. Refer to See: Instrument Panel, Gauges and Warning Indicators\Instrument Cluster / Carrier\Service and Repair\Removal and Replacement.
NO >> Repair the harness or connector.