ALLDATAdiy.com - 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)

Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)

Vehicle » Heating and Air Conditioning » Testing and Inspection » Component Tests and General Diagnostics » LAN System Circuit » Manual Air Conditioner

Manual Air Conditioner

LAN SYSTEM CIRCUIT

Diagnosis Procedure

DIAGNOSIS PROCEDURE FOR LAN CIRCUIT
1.CHECK POWER SUPPLY FOR DOOR MOTORS

Press ignition switch ON.

Check voltage between front air control connector M37 terminal 20 and ground.

Is the Inspection result normal?
YES >> GO TO 2
NO >> Replace front air control. Refer to See: Control Module HVAC\Service and Repair.
2.CHECK SIGNAL FOR DOOR MOTORS

Check voltage between front air control connector M37 terminal 3 and ground.

Is the Inspection result normal?
YES >> GO TO 3
NO >> Replace front air control. Refer to See: Control Module HVAC\Service and Repair.
3.CHECK POWER SUPPLY FOR MOTOR

Check voltage between mode door motor connector M127 terminal 3 and ground, between air mix door motor connector M130 terminal 3 and ground, and between intake door motor connector M126 terminal 3 and ground.

Is the Inspection result normal?
YES >> GO TO 4
NO >> Replace harness or connector.
4.CHECK SIGNAL FOR MOTOR

Check voltage between mode door motor connector M127 terminal 1 and ground, between air mix door motor connector M130 terminal 1 and ground, and between intake door motor connector M126 terminal 1 and ground.

Is the Inspection result normal?
YES >> GO TO 5
NO >> Replace harness or connector.
5.CHECK MOTOR GROUND CIRCUIT

Press ignition switch OFF.
Disconnect door motor connectors.

Check continuity between mode door motor connector M127 terminal 2 and ground, between air mix door motor connector M130 terminal 2 and ground, and between intake door motor connector M126 terminal 2 and ground.

Is the Inspection result normal?
YES >> GO TO 6
NO >> Replace harness or connector.
6.CHECK MOTOR OPERATION
Disconnect and reconnect the motor connectors and confirm the motor operation.
Is the Inspection result normal?
YES >> (Returns to normal operation.)

Motor connector contacts dirty or damaged NO >> (Does not operate normally.)
GO TO 7 7.CHECK MODE DOOR MOTOR AND AIR MIX DOOR MOTOR OPERATION

Disconnect the intake door motor connector.
Reconnect the mode door motor connector and air mix door motor connector, confirm the mode door motor and air mix door motor operation. Is the Inspection result normal?

YES >> (Mode door motor and air mix door motor operate normally.)

Replace the intake door motor. Refer to See: Air Door\Air Door Actuator / Motor\Service and Repair\Intake Door Motor. NO >> (Mode door motor and air mix door motor do not operate normally.)
GO TO 8 8.CHECK AIR MIX DOOR MOTOR AND INTAKE DOOR MOTOR OPERATION

Disconnect mode door motor connector.
Reconnect the intake door motor connector, confirm the air mix door motor and intake door motor operation. Is the Inspection result normal?

YES >> (Air mix door motor and intake door motor operate normally.)

Replace mode door motor. Refer to See: Air Door\Air Door Actuator / Motor\Service and Repair\Mode Door Motor. NO >> (Air mix door motor and intake door motor do not operate normally.)
GO TO 9 9.CHECK INTAKE DOOR MOTOR AND MODE DOOR MOTOR OPERATION

Disconnect air mix door motor connector.
Reconnect mode door motor connector, confirm the intake door motor and mode door motor operation. Is the Inspection result normal?

YES >> (Intake door motor and mode door motor operate normally.)

Replace inoperative air mix door motor. Refer to See: Air Door\Service and Repair. NO >> (Intake door motor and mode door motor do not operate normally.)
Replace front air control. Refer to See: Control Module HVAC\Service and Repair.