CAUTION: Before servicing SRS, turn the ignition switch off, disconnect both negative and positive battery terminals, then wait at least three minutes.
Disconnect both negative and positive battery terminals, then wait at least three minutes.
Disconnect seat belt pre-tensioner connector (1). Arrow Indicates Vehicle front
CAUTION:
For installing/removing seat belt pre-tensioner connector, insert a thin screwdriver wrapped with tape into the notch; lift locking tab then remove connector.
Install connector with lock raised, then push locking tab into connector.
Remove seat belt retractor screw (A) and retractor anchor bolt (B), then remove seat belt retractor (2) from center pillar.
INSTALLATION OF SEAT BELT RETRACTOR - COUPE
Installation is in the reverse order of removal.
Always perform an Inspection after repair to be sure the system is functioning within specifications. Refer to See: Procedures.
REMOVAL OF SEAT BELT RETRACTOR - SEDAN
CAUTION: Before servicing SRS, turn the ignition switch off, disconnect both negative and positive battery terminals, then wait at least three minutes.
Disconnect both negative and positive battery terminals, then wait at least three minutes.
Release the pawl, then remove outer anchor bolt cover and outer anchor bolt.
Remove D-ring anchor bolt from seat belt adjuster.
Remove seat belt retractor.
Disconnect the seat belt pre-tensioner connector.
CAUTION:
For installing/removing seat belt pre-tensioner connector, insert a thin screwdriver wrapped with tape into the notch; lift locking tab then remove connector.
Install connector with lock raised, then push locking tab into connector.
Remove screw and retractor anchor bolt, then remove seat belt retractor from center pillar.
Remove bolts, then remove seat belt adjuster from center pillar.
INSTALLATION OF SEAT BELT RETRACTOR- SEDAN
Installation is in the reverse order of removal.
Always perform an Inspection after repair to be sure the system is functioning within specifications. Refer to See: Procedures.
REMOVAL OF SEAT BELT BUCKLE
CAUTION: Before servicing SRS, turn the ignition switch off, disconnect both negative and positive battery terminals, then wait at least three minutes.
Disconnect the negative and positive battery terminals, then wait at least three minutes.