DOOR LOCK FRONT DOOR LOCK : Removal and Installation REMOVAL
Remove the front door finisher. Refer to See: Doors, Hood and Trunk\Front Door Panel\Service and Repair\Removal and Installation\Coupe .
Disconnect the inside handle knob cable and lock knob cable from the back side of the front door finisher.
Remove the front door window and front door module assembly. Refer to See: Doors, Hood and Trunk\Front Door Window Glass\Service and Repair\Removal And Installation .
Remove door side grommet, and remove door key cylinder assembly (driver side) and outside handle escutcheon (passenger side) bolts (TORX T30) from grommet hole.
Disconnect door antenna and door request switch connector and remove harness clamp.
Disconnect the key cylinder rod.
Disconnect door key cylinder switch harness connector.
While pulling the outside handle, remove door key cylinder assembly (driver side) or outside handle escutcheon (passenger side).
Disconnect front door request switch harness connector.
While pulling outside handle, slide toward rear of vehicle to remove outside handle.
Remove the front gasket and rear gasket.
Remove the TORX bolts (T30), remove the door lock assembly.
Remove the TORX bolt (T30) (A) from the outside handle bracket.
While pulling outside handle bracket, slide toward rear of vehicle to remove outside handle bracket.
Disconnect the door lock actuator connector and remove the door lock assembly.
Disconnect the outside handle cable from the outside handle bracket connection. INSTALLATION CAUTION: When installing the key cylinder rod be sure to rotate the key cylinder rod holder until a click is felt.
