Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » A L L Diagnostic Trouble Codes ( DTC ) » Testing and Inspection » B Code Charts » B210E » Sedan Without Intelligent Key  
 
 
  Sedan Without Intelligent Key  
 

B210E STARTER RELAY

Description
Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication.

DTC Logic

DTC DETECTION LOGIC

NOTE:

  

DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON under the following conditions and wait for at least 1 second.
    • CVT selector lever is in the P or N position
    • Do not depress the brake pedal
  1. Check "Self diagnostic result" with CONSULT-III. Is DTC detected?

YES >> Refer to Diagnosis Procedure.
NO >> Inspection End.

Diagnosis Procedure
1.CHECK STARTER RELAY OUTPUT SIGNAL

  1. Turn ignition switch OFF.
  2. Disconnect BCM harness connector.

  

  1. Check voltage between BCM harness connector and ground.

  

Is the Inspection result normal?
YES >> GO TO 3
NO >> GO TO 2
2.CHECK STARTER RELAY OUTPUT SIGNAL CIRCUIT

  1. Disconnect IPDM E/R harness connector.

  

  1. Check continuity between IPDM E/R harness connector and BCM harness connector.

  

  1. Check continuity between BCM harness connector and ground.

  

Is the Inspection result normal?
YES >> Replace IPDM E/R. Refer to See: Power and Ground Distribution\Power Distribution Module\Service and Repair.
NO >> Repair harness connector.
3.CHECK STARTER RELAY POWER SUPPLY CIRCUIT

  1. Turn ignition switch OFF.
  2. Disconnect IPDM E/R harness connector.

  

  1. Check voltage between IPDM E/R harness connector and ground.

  

Is the Inspection result normal?
YES >> Replace IPDM E/R. Refer to See: Power and Ground Distribution\Power Distribution Module\Service and Repair.
NO >> Check harness for open or short between IPDM E/R and battery.