B2560 STARTER CONTROL RELAY
Description
Starter control relay, integrated in IPDM E/R, permits the starter relay operation when in N or P position and the steering is locked or unlocked. It is installed in parallel with the starter relay.
DTC Logic
DTC DETECTION LOGIC
NOTE:
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
Turn ignition switch ON under the following conditions and wait for at least 2 seconds.
CVT selector lever is in the P position
Depress the brake pedal
Check "Self diagnostic result" with CONSULT-III. Is DTC detected? YES >> Refer to Diagnosis Procedure.
NO >> Inspection End.
Diagnosis Procedure
1.CHECK DTC WITH IPDM E/R
Check "Self diagnostic result" with CONSULT-III. Refer to See: Testing and Inspection .
Is the Inspection result normal?
YES >> GO TO 2
NO >> Repair or replace malfunctioning parts.
2.CHECK INTERMITTENT INCIDENT
Refer to See: Testing and Inspection\Initial Inspection and Diagnostic Overview\Service Information For Electrical Incident\Intermittent Incident .
>> Inspection End.