Description
The solenoid valve increases, holds or decreases the fluid pressure of each brake caliper according to the signals transmitted by the ABS actuator and electric unit (control unit).
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAGNOSIS RESULTS
Check the self-diagnosis results.
Is above displayed on the self-diagnosis display?
YES >> Proceed to diagnosis procedure.
NO >> Inspection end.
Turn ignition switch OFF and disconnect ABS actuator and electric unit (control unit) connector E26, check terminal for deformation, disconnection, looseness, and so on. If any malfunction is found, repair or replace terminal.
Reconnect connector and perform self-diagnosis. Is the Inspection result normal?
YES >> Inspection end.
NO >> GO TO 2 2.CHECK SOLENOID AND ACTUATOR RELAY POWER SUPPLY CIRCUIT
Turn ignition switch OFF and disconnect ABS actuator and electric unit (control unit) connector E26.
Check voltage between ABS actuator and electric unit (control unit) harness connector E26 terminal 3 and ground.
Is the Inspection result normal?
YES >> GO TO 3
NO >> - Repair or replace malfunctioning components.
Perform the self-diagnosis, and make sure that the result shows "NO DTC IS DETECTED".
CHECK SOLENOID AND ACTUATOR RELAY GROUND CIRCUIT
Check continuity between ABS actuator and electric unit (control unit) harness connector E26 terminal 1, 4 and ground.