BCM (BODY CONTROL MODULE)

Removal and Installation

REMOVAL

CAUTION:
Before replacing BCM, perform "READ CONFIGURATION" to save or print current vehicle specification. Refer to See: Body and Frame\Body Control Systems\Testing and Inspection\Programming and Relearning\Additional Service When Replacing Control Unit\Description.

1. Remove the combination meter. Refer to See: Instrument Panel, Gauges and Warning Indicators\Instrument Cluster / Carrier\Service and Repair\Removal and Replacement.

2. Remove the BCM screws (A), and pull out the BCM (1).
3. Disconnect the BCM connector and remove the BCM (1).

INSTALLATION
Installation is in the reverse order of removal.

CAUTION:

• When replacing BCM, perform "WRITE CONFIGURATION". Refer to See: Testing and Inspection\Configuration (BCM)\Description See: Testing and Inspection\Configuration (BCM)\Special Repair Requirement.
• When replacing BCM, perform the system initialization (NATS). Refer to the CONSULT-III operation manual for the initialization procedure.
• When replacing BCM, if new BCM does not come with keyfobs attached, all existing keyfobs must be re-registered. Refer to the CONSULT-III operation manual for the initialization procedure.